PT-CW330 Series

Ultra-short 1-chip DLP™ Projectors PT-CW331R/PT-CW330/PT-CW241R/PT-CW240/PT-CX301R/PT-CX300

Specifications

Model PT-CW331R/CW330 PT-CW241R/CW240 PT-CX301R/CX300
Power supply 100 - 240 V AC, 50/60 Hz
Power consumption 340 W
(0.5 W when
STANDBY MODE set to
ECO,*1 6.0 W when
STANDBY MODE set to
NORMAL.*2)
310 W
(0.5 W when
STANDBY MODE set to
ECO,*1 6.0 W when
STANDBY MODE set to
NORMAL.*2)
340 W
(0.5 W when
STANDBY MODE set to
ECO,*1 6.0 W when
STANDBY MODE set to
NORMAL.*2)
DLP™ chip Panel size 16.5 mm (0.65 in) diagonal 
(16:10 aspect ratio)
14 mm (0.55 in) diagonal 
(4:3 aspect ratio)
Display method DLP™ chip x 1 DLP™ system
Pixels 1,024,000 (1,280 x 800) pixels 786,432 (1,024 x 768) pixels
Lens Fixed (0.35:1 throw ratio), 
manual focus F = 2.6, f = -5.27 mm
Fixed (0.44:1 throw ratio), 
manual focus
F = 2.6, f = -5.27 mm
Lamp 280 W UHM lamp
(The lamp replacement cycle is 4,000 hours*3)
240 W UHM lamp
(The lamp replacement cycle is 5,000 hours*3)
280 W UHM lamp
(The lamp replacement cycle is 4,000 hours*3)
Screen size (diagonal) 1.78-2.54 m (70-100 in) 
(16:10 aspect ratio)
1.52-2.29 m (60-90 in) 
(4:3 aspect ratio)
Color reproducibility Full color (16,777,216 colors)
Brightness*4 3,100 lm 2,600 lm 3,100 lm
Center-to-corner uniformity*4 80 %
Contrast*4 8,000:1 (full on/off) (During RGB signal input, lamp power: Normal)
Resolution 1,280 x 800 pixels
(Input signals that exceed this resolution 
will be converted to 1,280 x 800 pixels.)
1,024 x 768 pixels
(Input signals that
exceed this resolution 
will be converted to
1,024 x 768 pixels.)
Scanning
frequency
HDMI (Horizontal) 15-100 kHz; (Vertical) 24-120 Hz; (Dot clock) 25-162 MHz
RGB (analog) (Horizontal) 15-100 kHz; (Vertical) 24-120 Hz; (Dot clock) 162 MHz or lower 
YPBPR (YCBCR)
fH: 15.75 kHz, fV: 60 Hz [480i (525i)]
fH: 31.50 kHz, fV: 60 Hz [480p (525p)]
fH: 45.00 kHz, fV: 60 Hz [720 (750)/60p]
fH: 33.75 kHz, fV: 60 Hz [1080 (1125)/60i]
fH: 27.00 kHz, fV: 24 Hz [1080 (1125)/24p]
fH: 56.25 kHz, fV: 50 Hz [1080 (1125)/50p]
fH: 15.63 kHz, fV: 50 Hz [576i (625i)]
fH: 31.25 kHz, fV: 50 Hz [576p (625p)]
fH: 37.50 kHz, fV: 50 Hz [720 (750)/50p]
fH: 28.13 kHz, fV: 50 Hz [1080 (1125)/50i]
fH: 67.50 kHz, fV: 60 Hz [1080 (1125)/60p]
Video/S-Video (fH) 15.75/15.63 kHz (fV) 50/60 Hz [NTSC/NTSC4.43/PAL/PAL60/PAL-N/PAL-M/SECAM]
Keystone correction range Vertical: ±15°
Installation Ceiling/floor, front/rear (Menu setting)
Built-in speaker 7cm x 3cm oval shape x 1, output power 10 W (monaural)
Terminals HDMI IN HDMI 19-pin x 1(Deep color, compatible with HDCP), 
audio signal: linear PCM (sampling frequencies: 48 kHz, 44.1 kHz, 32 kHz)
COMPUTER IN 1 D-sub HD 15-pin (female) x 1 [RGB/YPB(CB)/PR(CR) x 1]
COMPUTER IN 2 D-sub HD 15-pin (female) x 1 [RGB/YPB(CB)/PR(CR) x 1]
MONITOR OUT D-sub HD 15-pin (female) x 1 (The signal selected from computer input 1/2 is output.) 
VIDEO IN Pin jack x 1
S-VIDEO IN Mini DIN 4-pin x 1
COMPUTER 1 AUDIO IN M3 x 1 (L-R x 1)
COMPUTER 2 AUDIO IN M3 x 1 (L-R x 1)
VIDEO AUDIO IN Pin jack x 2 (L x 1, R x 1)
S-VIDEO AUDIO IN Pin jack x 2 (L x 1, R x 1)
AUDIO OUT M3 x 1 (L-R x 1) (variable)
SERIAL IN D-sub 9-pin (female) x 1 for external control (RS-232C compliant)
LAN RJ-45 x 1 (for network connection, 100BASE-TX/10BASE-T, 
compliant with PJLink™ (class 1))
Mini USB 1 for servicemen (for interactive function*5)
Power cord length 3.0 m (9'10")
Cabinet materials Molded plastic (PC)
Dimensions
(W x H x D)
357 x 250 x 367 mm (14-1/16 x 9-27/32 x 14-29/64 in)
(with legs at shortest position)
Weight PT-CW331R/
CW241R/
CX301R
Approximately
7.8 kg (17.2 lbs)*6
Approximately
7.6 kg (16.7 lbs)*6
Approximately
7.8 kg (17.2 lbs)*6
PT-CW330/
CW240/
CX300
Approximately
7.7 kg (17.0 lbs)*6
Approximately
7.5 kg (16.5 lbs)*6
Approximately
7.7 kg (17.0 lbs)*6
Noise level*4 37 dB
(Lamp power: Normal);
33 dB (Lamp power: Eco)
35 dB
(Lamp power: Normal);
30 dB (Lamp power: Eco)
37 dB
(Lamp power: Normal);
33 dB (Lamp power: Eco)
Operating temperature 5°C-40°C [41°F-104°F] (Less than 762 m [2,500 ft] above sea level); 
5°C-35°C [41°F-95°F] (between 762 and 1,524 m [2,500 ft and 5,000 ft] above sea level);
5°C-30°C [41°F-86°F] (between 1,524 and 3,048 m [5,000 ft and 10,000 ft] above sea level)
Operating humidity 20 %-80 % (no condensation)
Supplied accessories PT-CW331R/
CW241R/
CX301R
Power cord x 1( x 2 for PT-CW331REA, PT-CW241REA, PT-CX301REA), power cord cover x 1, wireless remote control unit x 1, battery for remote control (lithium coin cell type x 1), computer cable (1.8 m, for VGA) x 1, interactive pen x 2, batteries for interactive pen (AAA/R03/LR03 type x 4), USB cable (5.0 m) x 1, software CD-ROM (LightPen3) x 1
PT-CW330/
CW240/
CX300
Power cord x 1( x 2 for PT-CW330EA, PT-CW240EA, PT-CX300EA), power cord cover x 1, 
wireless remote control unit x 1, battery for remote control (lithium coin cell type x 1), 
computer cable (1.8 m, for VGA) x 1
  • * Product numbers vary depending on the market. The general guideline is as follows:
    The product number in the Americas and Taiwan is PT-CW331RU, PT-CW330U, PT-CW241RU, PT-CW240U, PT-CX301RU and PT-CX300U.
    The product number in Europe (except the UK) and CIS is PT-CW331RE, PT-CW330E, PT-CW241RE, PT-CW240E, PT-CX301RE and PT-CX300E.
    The product number in the UK, Asia (except Taiwan), Oceania, Middle East, and Africa is PT-CW331REA, PT-CW330EA, PT-CW241REA, PT-CW240EA,
    PT-CX301REA and PT-CX300EA.
  • *1 When [LAN (Standby)]/[VGA Out (Standby)]/[In Standby Mode (Audio)] are all set to [Off].
    *2 When [LAN (Standby)]/[VGA Out (Standby)]/[In Standby Mode (Audio)] are all set to [On].
    *3 This is the maximum value when the lamp power is set to Eco mode where the lamp is turned on for 2 hours and off for 0.25 hours. If the lamp is turned on more times or kept on for a long time, the lamp replacement cycle will shorten. In Normal mode, the lamp replacement cycle is 3,500 hours for the PT-CW241R/CW240 and 3,000 hours for the PT-CW331R/CW330/CX301R/CX300. The usage environment affects the duration of the lamp.
    *4 Measurement, measuring conditions, and method of notation all comply with ISO 21118 international standards.
    *5 Exclusively for PT-CW331R/CW241R/CX301R.
    *6 The above values are averages. Actual values may be different according to the product.
NOTES ON USE
1 The projector uses a high-voltage mercury lamp under high internal pressure. This lamp may break, emitting a popping sound, or fail to illuminate, due to impact or extended use.
2 The high-wattage lamp becomes very hot during operation. Please observe the following precautions:
• Never place objects on top of the projector while it is in operation.
• Make sure there is an unobstructed space of 500 mm (19-11/16 in) or more around the projector’s exhaust openings.
• If stacking projector units, care must be taken to provide the recommended space between units. These space requirements also apply to installation where only one projector unit is operating at one time and the other unit is used as a backup.
• If the projector is placed in a box or enclosure, the temperature of the air surrounding the projector must match the operating temperature listed in the specifications table during use. Also, make sure the projector’s intake and exhaust openings are not blocked. Ensure there is sufficient ventilation to prevent hot air from the exhaust openings being recirculated into the intake opening.
3 The lamp replacement cycle duration becomes shorter if the projector is operated repeatedly for short periods.
• The lamp replacement cycle varies greatly depending on individual lamp characteristics and usage conditions.
• The brightness of the lamp will gradually decrease with use.
4 Due to natural characteristics of lamps, screen brightness may fluctuate. This is not an indication of faulty lamp performance.